
Installation Instructions for Innotech Genesis Systems
Edition 011100
4-20
Figure 4-6. Address Jumpers, Typical Settings.
Figure 4-7. End-of-Cable Jumper, Typical Location.
4-1.4.3.
Analogue Output Jumpers. An analogue output jumper plug arrangement
is provided for each analogue output channel. The three-pin jumper sockets will accept a
shorting plug between the centre pin and either of the outside pins. Depending upon which
pair of pins the jumper is connected to, the analogue output is configured for either the
Variable Mode or the Heat Valve Mode. For inactive analogue output channels, the jumper
is not installed in either position. In such cases the jumper plug can be conveniently stored
in the unit by inserting only one end of the plug into the socket.
JIHGFEDCBA
AI5 AI6 AI7 AI8 AI9
+
+
+
+
+
----
Sensor #7
Sensor #11
Sensor #10
Sensor #9
Sensor #8
Address
jumpers
A0
A1
A1<not used>
A2
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
TD1: 0-250 µAmps
OPEN
PORTION OF COMPUTER-GENERATED WIRING
DIAGRAM SHOWING ANALOGUE INPUT MODULE
GEN II AI REM
1 2
3
JUMPER
Comentarios a estos manuales