
© MASS ELECTRONICS Pty Ltd 2011
DS 99.05 – Ethernet Setup Manual for Device Communications
Page 2
Edition 1.0 dated 04/10/11
1
Overview
This document provides instructions for conguring the Ethernet settings on Innotech
controllers and devices equipped with an Ethernet port. Depending on the controller or
device, this can be accomplished with either the EtherMate software from Innotech, or
with the embedded web server where applicable. Detailed information for conguring
and commissioning Ethernet connections on applicable Innotech device(s) is provided.
This manual also contains a general troubleshooting section to assist you in conguring
Ethernet settings on devices where the IP address of the Innotech device is unknown or
has been lost.
If installing on a shared network, site installation and Ethernet commissioning
will in most cases involve compliance with the requirements of the IT Manager for
Networking and Information Security. Technicians performing the installation are
advised to contact the IT Manager on site for specic site installation instructions.
This is not necessary for installations on a dedicated network.
Document layout
This document consists of the following chapters as described below:
About this document contains general information such as document
conventions, required software and tools, and computer specications.
Preliminary Information contains general information on Ethernet standards
and Ethernet cabling information.
Connecting Innotech devices for initial conguration contains
information on different ways you can connect your Innotech devices to
congure the Ethernet settings for permanent deployment on your LAN.
Conguring Ethernet settings of Innotech devices contains instructions to
congure the Ethernet settings on your devices to prepare for installation on
your LAN.
General troubleshooting contains general troubleshooting tips.
Chapter 1:
Chapter 2:
Chapter 3:
Chapter 4:
Chapter 5:
Document conventions
The following conventions are used in this document:
Convention Description
boldface
Boldface text indicates commands, keywords, mouse clicks, or menu
selections you use to do a task
italics Italic text indicates a value you must supply and enter
NOTE Indicates useful information, or tips that you should read and understand
Caution Indicates critical information you MUST read before proceeding further
Intended audience
This document is intended for commissioning personnel.
Comentarios a estos manuales