Innotech Maxim Manual de usuario descargar pdf (Pagina 38)

MAXIM Installation Instructions

Page 38 © Mass Electronics Pty Ltd 2011Edition 2.0 dated 20/11/2013

3-3.4 IG01 Sub System Gateway

This section of the manual provides wiring information for the IG01 Sub System Gateway. Information

is provided on wiring a power source and all associated inputs and outputs.

The general layout of the input and output terminals for each of these controllers is illustrated in

Figure 3-9 below.

POWER

SSG

COMMS

(RS485)

NET & GLOBAL

COMMS

(RS485)

ETHERNET

3-3.4.1 Power Input

The IG01 Sub System Gateway may by powered by either an AC or a DC power source. The operating

voltage must meet the requirements of Safety Extra Low Voltage (SELV) to EN60730. The transformer

used must be a safety transformer in compliance with EN60742 and be designed for 100% duty. It

must also be sized and fused in compliance with local safety regulations. Power input specifications

for these controllers are detailed in Table 3-13 below.

Figure 3-9: IG01 Sub System Gateway Terminal Connection Layout

Table 3-13: IG01 Sub System Gateway Power Source Specifications

AC Power Source DC Power Source

24 VAC ±10%, 50/60 Hz,

Nominal Transformer rating 8VA or greater

24 V DC ±10%

Nominal Transformer rating: 8VA or greater

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Sin comentarios

Innotech Maxim Manual de usuario Pagina 38